Mensaje por Rascador » 15 Ene 2021 14:52
De la wiki. Diferencias entre generaciones y la llamada a revision.
586 (no dash), 1980 Introduction model
586-1, 1986 radius stud package, floating hand
586-2, 1987 changed hammer nose, bushing and associated parts
586-M, 1987 Product warning by S&W: M over stamped to signify a modification by factory or warranty station for 586 and 586-1
586-3, 1988 new yoke retention system
586-4, 1993 change rear sight leaf, drill and tap frame, change extractor, Hogue grips
586-5, 1997 delete 8 3/8" barrel/change to MIM thumbpiece/Ship with Master trigger locks
586-6, 1997 change frame design to eliminate cylinder stop stud, eliminate serrated tangs, MIM hammer and trigger, change to internal lock.
586-7, 2004 Performance Center .38 Super, 6-Shot unfluted cylinder, 4" barrel, Stainless Steel, 250 Made, seven shot with internal lock
586-8, 2012 Reintroduction as a Classic Series with internal lock 6-shot 4" and 6" RR, WO TS SB[3]
In 1987, seven years after the release of the Model 686, there were reports of cylinder binding with some types of standard .357 Magnum ammunition for L-frame revolvers manufactured before August 1987. S&W put out a product warning and authorized a no-charge upgrade to make modifications to the revolver. All recalled and reworked guns were stamped with an M marking, signifying that they had been recalled and fixed; thus it is known as the M modification for all 686, 686-1, 586-1, and 586-2 revolvers.[4]
De la wiki. Diferencias entre generaciones y la llamada a revision.
586 (no dash), 1980 Introduction model
586-1, 1986 radius stud package, floating hand
586-2, 1987 changed hammer nose, bushing and associated parts
586-M, 1987 Product warning by S&W: M over stamped to signify a modification by factory or warranty station for 586 and 586-1
586-3, 1988 new yoke retention system
586-4, 1993 change rear sight leaf, drill and tap frame, change extractor, Hogue grips
586-5, 1997 delete 8 3/8" barrel/change to MIM thumbpiece/Ship with Master trigger locks
586-6, 1997 change frame design to eliminate cylinder stop stud, eliminate serrated tangs, MIM hammer and trigger, change to internal lock.
586-7, 2004 Performance Center .38 Super, 6-Shot unfluted cylinder, 4" barrel, Stainless Steel, 250 Made, seven shot with internal lock
586-8, 2012 Reintroduction as a Classic Series with internal lock 6-shot 4" and 6" RR, WO TS SB[3]
In 1987, seven years after the release of the Model 686, there were reports of cylinder binding with some types of standard .357 Magnum ammunition for L-frame revolvers manufactured before August 1987. S&W put out a product warning and authorized a no-charge upgrade to make modifications to the revolver. All recalled and reworked guns were stamped with an M marking, signifying that they had been recalled and fixed; thus it is known as the M modification for all 686, 686-1, 586-1, and 586-2 revolvers.[4]
