Mensaje por VLZ » 19 Dic 2014 20:24
Sería para Classic, pero estoy leyendo que ...
Classic Division
1 Minimum power factor for Major 170
2 Minimum power factor for Minor 125
3 Minimum bullet weight No
4 Minimum bullet caliber / cartridge case length 9mm (0.354") / 19mm (0.748")
5 Minimum bullet caliber for Major 10mm (0.40"), see below
6 Minimum trigger pull (see Appendix E4) No
7 Maximum handgun size Yes, see below
8 Maximum magazine length Yes, see below
9 Maximum ammunition capacity Yes, see below
10 Max. distance of handgun and allied equipment from torso 50mm
11 Rule 5.2.10 / Appendix E2 applies Yes
12 Optical/electronic sights No
13 Compensators, ports, sound and/or flash suppressors No
A handgun in its ready condition (see Section 8.1), but unloaded and with an empty magazine inserted, must fit wholly within the confines of a box which has internal dimensions of 225mm x 150mm x 45 mm (tolerance of +1 mm, -0 mm). Note that all magazines must comply.
The handgun is placed inside the box with the barrel parallel to the longest side of the box. Rear adjustable sights may be slightly depressed during insertion.
Handguns must be based on and visibly resemble the classic 1911-genre design. This means a single-stack, one piece metal frame, and a dust cover (without an accessory rail) which has a maximum length of 75mm when measured from the leading edge of the dust cover to the rear of the slide stop pin. Magazine well openings cannot exceed a maximum outside width of 35mm. Compliance is checked by way of a 35mm wide, and at least 5mm deep, notch carved into the outside of the box, or by use of a ruler or caliper, as approved by the Range Master.
Prohibited modifications are slide lightening cuts, weak hand thumb rests and slide rackers.
Permitted modifications are those of a cosmetic nature (e.g. custom grip panels, scrimshaw or similar surface engravings, checkering or serrations etc.), replacement single or ambidextrous thumb safeties, and any open sights (which may be embedded into the slide).
Magazines accessible to a competitor during a COF must not contain more than 8 rounds (for Major power factor) or 10 rounds (for Minor power factor) at the Start Signal.
357SIG is also an approved caliber for Major, subject to achieving the applicable minimum power factor. This concession expires 31 December 2014.
This Division is under evaluation and, unless extended, it will expire on 31 December 2014.
¿Esto es así? ¿la división Classic expira el 31 de Diciembre de este año?
Sería para Classic, pero estoy leyendo que ...
[size=50]Classic Division
1 Minimum power factor for Major 170
2 Minimum power factor for Minor 125
3 Minimum bullet weight No
4 Minimum bullet caliber / cartridge case length 9mm (0.354") / 19mm (0.748")
5 Minimum bullet caliber for Major 10mm (0.40"), see below
6 Minimum trigger pull (see Appendix E4) No
7 Maximum handgun size Yes, see below
8 Maximum magazine length Yes, see below
9 Maximum ammunition capacity Yes, see below
10 Max. distance of handgun and allied equipment from torso 50mm
11 Rule 5.2.10 / Appendix E2 applies Yes
12 Optical/electronic sights No
13 Compensators, ports, sound and/or flash suppressors No
A handgun in its ready condition (see Section 8.1), but unloaded and with an empty magazine inserted, must fit wholly within the confines of a box which has internal dimensions of 225mm x 150mm x 45 mm (tolerance of +1 mm, -0 mm). Note that all magazines must comply.
The handgun is placed inside the box with the barrel parallel to the longest side of the box. Rear adjustable sights may be slightly depressed during insertion.
Handguns must be based on and visibly resemble the classic 1911-genre design. This means a single-stack, one piece metal frame, and a dust cover (without an accessory rail) which has a maximum length of 75mm when measured from the leading edge of the dust cover to the rear of the slide stop pin. Magazine well openings cannot exceed a maximum outside width of 35mm. Compliance is checked by way of a 35mm wide, and at least 5mm deep, notch carved into the outside of the box, or by use of a ruler or caliper, as approved by the Range Master.
Prohibited modifications are slide lightening cuts, weak hand thumb rests and slide rackers.
Permitted modifications are those of a cosmetic nature (e.g. custom grip panels, scrimshaw or similar surface engravings, checkering or serrations etc.), replacement single or ambidextrous thumb safeties, and any open sights (which may be embedded into the slide).
Magazines accessible to a competitor during a COF must not contain more than 8 rounds (for Major power factor) or 10 rounds (for Minor power factor) at the Start Signal.
357SIG is also an approved caliber for Major, subject to achieving the applicable minimum power factor. This concession expires 31 December 2014.[/size]
[b][u]
This Division is under evaluation and, unless extended, it will expire on 31 December 2014. [/u][/b]
¿Esto es así? ¿la división Classic expira el 31 de Diciembre de este año?
